The plastic flakes from the grinding process are fed into an extrusion machine.

The extrusion machine melts the plastic flakes using heat and mechanical pressure.

The molten plastic is filtered to remove any impurities or contaminants.

The melted plastic is then forced through a die, forming long strands of plastic.

These strands are cooled in a water bath to solidify.

After cooling, the strands are cut into uniform, small granules using a pelletizer or granulator.

The granules are stored in bags or containers, ready to be used in the injection molding process.

This step transforms recycled scrap into a consistent raw material for manufacturing.

Granules produced from scrap may vary slightly in color and properties depending on the scrap quality.

The granules are carefully tested for uniformity and quality to ensure good performance in the next stage.